Invite students to class
Introduction
A class is only useful once your students are in it. CodeChum lets them in with a class code, a short string that belongs to that one class, so you never type a list of names and nobody joins a class they were not given the code for.
You hand the code out once. After that your job is to let in the students who ask, from the Class Record tab.
Steps
Note: You need a class before you can invite anyone. If you have not made one yet, start with Create a class.
To get your students into your class, follow these instructions:
- Open your class and stay on the Activities tab. The Class code card sits at the top left, and the code on it is your class's code and its number joined with a dash.

- Click the copy button beside the code. It reads Copy to Clipboard until you use it, then turns green and reads Copied.

Note: If your school has no active partnership with CodeChum, the card is locked and reads You need to partner with us first to invite students, with a Book a call to partner button in place of the code.
- Send the code to your students however you normally reach them. They each need a CodeChum account first, so point them at Sign up as a student, then at Join a class to type the code in.
- Wait for them to ask. A class that needs your approval leaves each student on Request sent!, and you get a notification in the bell at the top of the page reading There are new requests to join your class and the class's name. The Class Record tab carries a red count of the students waiting.

- Open the Class Record tab of that class and click Students waiting for acceptance. The number beside it is how many have asked, and the list opens under it, one card per student with their last name, first name and email.

- Finally, click the green check on a card to let the student in, or the red cross beside it to turn the request down. A green message reads Student successfully added to class., the card leaves the list, and the student appears in the table below.

Note: While nobody is enrolled, the Class Record tab shows the class code again, under Invite your students with this class code so they can answer the activities in your class, with the same copy button. It is the quickest place to pick the code up later.
Other requests waiting in your bell
The bell holds more than class requests. Click a notification to open it and answer it there:
- Request for Password Reset names a student of your class or your university and reads requested for their password to be reset.
- Invitation To Join University names the teacher who sent it and their university, and reads invited you to join their university. Accepting moves your account to that university.
Either one has the same two buttons, Accept and Decline. Whichever you click, CodeChum answers with a Success window and a Finish button, and takes the notification out of the list. Closing the window without choosing leaves the notification where it was.
And that's how you invite students to your class in CodeChum! Next, let's give your students an activity.
